Impacts of Diatomaceous Earth on the Properties of Cement Pastes

  • Bashir Hasanzadeh Dept. of Civil and Environmental Engineering, Univ. of Louisville, Louisville, KY 40292.
  • ZhiHui Sun Dept. of Civil and Environmental Engineering, Univ. of Louisville, Louisville, KY 40292.
Keywords: Fresh properties, diatomaceous earth, rheology, isothermal calorimetry, setting time, bleeding

Abstract

Fresh properties of concrete are closely related to operation and construction, such as transporting, placing, compacting, etc.; and they also have a great impact on the lifetime performance of concrete. In this paper, the influence of Diatomaceous Earth (DE) as a natural pozzolan on fresh properties of cement pastes has been investigated. Cement pastes with different water-to-binder ratios (w/b=0.4, 0.5 and 0.6) and 0%, 2%, 6% and 10% replacement levels of DE by weight of cement were studied. Viscosity, yield stress, flow diameter, bleeding, setting times, and the heat evolution of all cement pastes were measured. Results showed that DE has a significant impact on fresh properties of cement pastes. Increasing DE content in cement pastes resulted in higher viscosity and lower flow diameters. Pastes with higher DE replacement levels showed lower bleeding rate and shorter initial and final setting times. The isothermal calorimetry test also showed that, as a pozzolanic material, DE lowered the heat of hydration, however, it advanced the appearance of the heat evolution peaks which was in agreement with the results from setting time tests.

References

Agullo, L., Toralles-Carbonari, B., Gettu, R., & Aguado, A. (1999). Fluidity of cement pastes with mineral admixtures and superplasticizer—a study based on the Marsh cone test. Materials and Structures, 32(7), 479-485.

ASTM C1702. (2009). Standard test method for measurement of heat of hydration of hydraulic cementitious materials using isothermal conduction calorimetry. ASTM International West Conshohocken, Pa.

ASTM C191. (2008). Standard Test Method for Time of Setting of Hydraulic Cement by Vicat Needle. ASTM International West Conshohocken, Pa.

Aydin, A. C., & Gül, R. (2007). Influence of volcanic originated natural materials as additives on the setting time and some mechanical properties of concrete. Construction and building materials, 21(6), 1277-1281.

Bakr, H. E. G. M. M. (2010). Diatomite: its characterization, modifications and applications. Asian journal of materials science, 2(3), 121-136.

Banfill, P. (1990). Rheology of Fresh Cement and Concrete: Proceedings of an International Conference, Liverpool, CRC Press.

Banfill, P. (2003). The rheology of fresh cement and concrete − A review. In International Cement Chemistry Congress. Durban.

Bouras, R., Kaci, A., & Chaouche, M. (2012). Influence of viscosity modifying admixtures on the rheological behavior of cement and mortar pastes. Korea-Australia Rheology Journal, 24(1), 35-44.

Degirmenci, N., & Yilmaz, A. (2009). Use of diatomite as partial replacement for Portland cement in cement mortars. Construction and Building Materials, 23(1), 284-288.

Dolley, P. (1999). Diatomite: Minerals Yearbook: Volume I-Metals and Minerals. US Geological Survey, p. 1-4.

Ergün, A. (2011). Effects of the usage of diatomite and waste marble powder as partial replacement of cement on the mechanical properties of concrete. Construction and building materials, 25(2), 806-812..

Ferraris, C. F., Obla, K. H., & Hill, R. (2001). The influence of mineral admixtures on the rheology of cement paste and concrete. Cement and concrete research, 31(2), 245-255.

Fragoulis, D., Stamatakis, M. G., Papageorgiou, D., & Chaniotakis, E. (2005). The physical and mechanical properties of composite cements manufactured with calcareous and clayey Greek diatomite mixtures. Cement and Concrete Composites, 27(2), 205-209.

He, Q., Gong, X., Xuan, S., Jiang, W., & Chen, Q. (2015). Shear thickening of suspensions of porous silica nanoparticles. Journal of materials science, 50(18), 6041-6049.

Jewell, S. & Kimball, S.M. (2015). MINERAL COMMODITY SUMMARIES 2015, in annual U.S. Geological Survey.

Jewell, S., & Kimball S.M. (2016). MINERAL COMMODITY SUMMARIES 2016, in annual U.S. Geological Survey: USGS.

Jud Sierra, E., Miller, S. A., Sakulich, A. R., MacKenzie, K., & Barsoum, M. W. (2010). Pozzolanic activity of diatomaceous earth. Journal of the American Ceramic Society, 93(10), 3406-3410.

Kastis, D., Kakali, G., Tsivilis, S., & Stamatakis, M. G. (2006). Properties and hydration of blended cements with calcareous diatomite. Cement and concrete research, 36(10), 1821-1826.

Kim, J. H., Kwon, S. H., Kawashima, S., & Yim, H. J. (2017). Rheology of cement paste under high pressure. Cement and Concrete Composites, 77, 60-67.

Liu, F., Sun, Z., & Qi, C. (2014). Raman spectroscopy study on the hydration behaviors of Portland cement pastes during setting. Journal of Materials in Civil Engineering, 27(8), 04014223.

Lootens, D., Hébraud, P., Lécolier, E., & Van Damme, H. (2004). Gelation, shear-thinning and shear-thickening in cement slurries. Oil & gas science and technology, 59(1), 31-40.

Miller, S. A., Sakulich, A. R., Barsoum, M. W., & Jud Sierra, E. (2010). Diatomaceous Earth as a Pozzolan in the Fabrication of an Alkali‐Activated Fine‐Aggregate Limestone Concrete. Journal of the American Ceramic Society, 93(9), 2828-2836.

Mostafa, N. Y., & Brown, P. W. (2005). Heat of hydration of high reactive pozzolans in blended cements: isothermal conduction calorimetry. Thermochimica acta, 435(2), 162-167.

Nägele, E. (1985). The zeta-potential of cement. Cement and Concrete Research, 15(3), 453-462.

Pang, X., Bentz, D. P., Meyer, C., Funkhouser, G. P., & Darbe, R. (2013). A comparison study of Portland cement hydration kinetics as measured by chemical shrinkage and isothermal calorimetry. Cement and Concrete Composites, 39, 23-32.

Plank, J., & Hirsch, C. (2007). Impact of zeta potential of early cement hydration phases on superplasticizer adsorption. Cement and concrete research, 37(4), 537-542.

Rahhal, V., & Talero, R. (2009). Calorimetry of Portland cement with silica fume, diatomite and quartz additions. Construction and Building Materials, 23(11), 3367-3374.

Robert, D. Crangle, J. (2013) DIATOMITE, Mineral Yearbook 2013, in annual. U.S. Geological Survey: Mineral Yearbook. p. 22.1-22.5.

Roussel, N. (2006). A thixotropy model for fresh fluid concretes: theory, validation and applications. Cement and Concrete Research, 36(10), 1797-1806.

Stamatakis, M. G., Fragoulis, D., Csirik, G., Bedelean, I., & Pedersen, S. (2003). The influence of biogenic micro-silica-rich rocks on the properties of blended cements. Cement and Concrete Composites, 25(2), 177-184.

Sun, Z., & Young, C. (2014). Bleeding of SCC pastes with fly ash and GGBFS replacement. Journal of Sustainable Cement-Based Materials, 3(3-4), 220-229.

Taylor, H. F. (1997). Cement chemistry. Thomas Telford.

Wallevik, J. E. (2006). Relationship between the Bingham parameters and slump. Cement and Concrete Research, 36(7), 1214-1221.

Yahia, A. (2011). Shear-thickening behavior of high-performance cement grouts—Influencing mix-design parameters. Cement and concrete research, 41(3), 230-235.

Yahia, A. (2014). Effect of solid concentration and shear rate on shear-thickening response of high-performance cement suspensions. Construction and Building Materials, 53, 517-521.

Yılmaz, B., & Ediz, N. (2008). The use of raw and calcined diatomite in cement production. Cement and Concrete Composites, 30(3), 202-211.

Published
2019-01-19
How to Cite
Hasanzadeh, B., & Sun , Z. (2019). Impacts of Diatomaceous Earth on the Properties of Cement Pastes. Journal of Building Materials and Structures, 5(2), 197-211. https://doi.org/10.34118/jbms.v5i2.58
Section
Original Articles